Trade Seal - Building Envelope Penetration Seal

TRADE SEALS – Building Envelope Penetration Seal

1 piece Self Adhesive Waterproofing Collar for sealing around Pipe & Conduit

• One Component Secondary Flashing System
• Can be used on all accepted Wall Underlays including Bituminous Paper
• Can be installed on the inside of RAB systems & Wall Underlay’s - Retrofit Installation
• Requires NO Adhesives to hold in place
• Can be left exposed to Weather & UV for up to 90 Days
• Will Adhere to most clean & dry substrates including Fibre Cement & Ply RAB Board
• Additional Sizes: 8-12mm, 42-55mm, 75-90mm, 125-135mm & 200-220mm  POA, Leadtime 2 Days

Installation Instructions:

1. Select size of TRADE-SEAL—Collar should be Tight
2. Trade-Seal Collar extension should be trimmed to get the best fit
3. Trade-Seal must not be forced onto the penetration
4. Ensure the surface to receive the Trade-Seal is clean & dry
5. Remove the backing paper & slide the collar over penetration
6. Adhere Trade-Seal at  45˚ to aid moisture run off
7. Smooth Trade-Seal onto the substrate to ensure adhesion
8. Push Trade-Seal collar back onto penetration to fit cavity width

Click here for Broucher.

Click here for the Specification Sheet.

Click here for Installation Guide.

Click here for Warranty.